Table of Contents
Advertisement
Connecting phones
The gateway includes one RJ-14 port (Phone 1 & 2) with the capacity to support 2
phone lines using a splitter or multi-jack adapter.
WARNING:
Do not connect the VoIP lines to your current home telephone wiring,
especially if your home has an alarm system. Ensure that you are subscribed to VoIP
service before configuring VoIP on the gateway.
1. Connect one end of the phone cable to the gray Phone Lines 1 & 2 port on the
gateway.
2. Do one of the following:
•
For one phone, connect the phone cable directly to the telephone.
•
For two phones, connect the phone cable to a splitter and then to the
telephones.
After the gateway recognizes the phones (Line 1 and Line 2), the Phone 1 and
Phone 2 lights turn steady green and blink when the associated phone is active.
Configuring the gateway
If necessary, you can use the gateway configuration page to view or change the
gateway settings.
On a computer connected to the gateway, enter the following into the address bar of a
Web browser:
•
http://192.168.1.254
You can also use http://gateway.pace.net to access the gateway configuration page.
Chapter 2
Installing the Gateway
11
Advertisement
Table of Contents
