Figure 3-3 The Back Panel
Table 3-3 describes the interfaces and buttons on the back panel of the ZXHN
H268A.
Table 3-3 The Back Panel
Interface/Button
DSL
Phone1–Phone2
LAN1–LAN4
WAN
WPS
Reset
WLAN
Power
3.2 Hardware Connection
Figure 3-4 shows the devices that are connected to interfaces of the ZXHN
H268A
Function
RJ-11 port: It is used to connect to the DSL uplink access
network.
RJ-11 port. It is used to connect to the phone through the
telephone line.
RJ-45 port. It is used to connect the modem to computer,
STBs or other network devices.
RJ-45 port. It is used to connect to the network provided by
the ISP.
WLAN Protected Setup
After power on the ZXHN H268A, hold on this button for more
than 5 seconds to reset the current settings to the factory
default setting, and then the system automatically restarts.
WLAN switch. Turn on or turn off the WLAN.
Power supply port. It is connected to the power adapter.