Table of Contents
Advertisement
The ATM PVC Configuration screen allows you to configure an ATM PVC
identifier (VPI and VCI) and select a service category.
Verify the following values with your ISP before you change them.
•
VPI: Virtual Path Identifier. The valid range is 0 to 255.
•
VCI: Virtual Channel Identifier. The valid range is 32 to 65535.
•
Service Category: Five classes of traffic are listed—
o UBR Without PCR
o UBR With PCR
o CBR
o Non Realtime VBR
o Realtime VBR
Enabling QoS for a PVC improves performance for selected classes of
applications. However, since QoS also consumes system resources, the
number of PVCs is reduced. If you want to enable QoS service, click on the
Enable Quality Of Service check box.
Connection Type
This screen shows the below types of network protocols and encapsulation
modes—
•
PPP over ATM (PPPoA)
•
PPP over Ethernet (PPPoE)
•
MAC Encapsulation Routing (MER)
•
IP over ATM (IpoA)
•
Bridging
Select the mode that your ISP has instructed you to use and click on Next.
Also available is the option to enable 802.1q, a standard to allow multiple
bridged networks to transparently share the same physical network link
without leakage of information between networks (i.e. "trunking"). Click on
the checkbox if you wish to enable this function.
Zhone Bonded Channel
User Manual
Version 1.1
Document #: BD-ZU0007-11
27
Advertisement
Table of Contents
