Marksman X6 Installation Manual page 23

Engine Crank Detection Programming
Step 3A Crank Detection Programming and Procedure
Press
Chirp/
Buttons
LED Flash
1
+
Step 3B Crank Detection Programming and Procedure
Press
Chirp/
Buttons
LED Flash
Tachometer
2
+
Step 3C Crank Detection Programming and Procedure
Press Chirp/
Buttons
LED Flash
3
Fixed Crank
+
Checking
Type
Voltage
A. Press the
Type
for more than 10 seconds.
A1. If the engine shuts off before 10 seconds, follow the "Engine Crank
Detection Programming" Step 1 and Step 2 procedure on page 22 to
change "low check level" to "hi check level" (2 chirps). Exit the
programming mode and Repeat A above.
A2. If the engine cranks too long or too little, follow the "Engine Crank
Detection Programming" Step 1 and Step 2 procedure on page 22 to
select a different crank duration (see chart enclosed). Exit the
programming mode and Repeat A/A1 above.
Checking
Type
A. Learn the engine idle RPM.
Type 1. Press and release the
2. Start the engine with the ignition key and allow the choke to turn off.
3. With the engine at true idle speed, press and hold the valet switch
until you hear (1) long chirp and the LED is on solid for two seconds.
Note: If you do not get a response from holding down the valet switch,
check your tach connection. It may be loose or incorrect.
4. Turn off the ignition key.
B. Press the
for more than 10 seconds.
B1. If the engine shuts off before 10 seconds, follow the "Engine Crank
Detection Programming" Step 1 and Step 2 procedure on page 22 to
change "high check level" to "low check level" (2 chirps). Repeat B
above.
B2. If the engine cranks too long or too little, follow the "Engine Crank
Detection Programming" Step 1 and Step 2 procedure on page 22 to
select a different crank duration (see chart enclosed). Repeat B/B1
above.
Checking
Type
A. Press
than 10 seconds.
Mode
A1. If the engine cranks too long or too little, follow the "Engine Crank
Detection Programming" Step 1 and Step 2 procedure on page 22 to
select a different crank duration (see chart enclosed). Repeat A above.
(continued)
Test and Adjustment Procedure
button two times to start the engine. Allow engine to run
Test and Adjustment Procedure
button on the transmitter.
button two times to start the engine. Allow engine to run
Test and Adjustment Procedure
two times to start the engine. Allow engine to run for more
23