HOW TO REMOVE THE BELT
The belt made of a special compound. If the
belt becomes worn or breaks, replace the
belt with an original equipment belt.
1. Disconnect the spark plug wire from the
spark plug.
2. Pull the clutch lever back to release the
tension from the belt.
3. Remove the two screws and spacers
from the top of the engine pulley cover.
Remove the engine pulley cover (see
Figure 17).
Screws
F-031 102C
SERVICE AND ADJUSTMENT
Spacer
Spacer
Engine
Pulley
Belt
Guide
Screw
Engine
Pulley
Cover
Figure 17
4. Loosen, do not remove, the screw that
holds the belt guide. Then, move the
belt guide away from the belt.
5. Remove the screws from the belt guard
(see Figure 18).
6. Remove the old belt from the engine
and quill assembly pulleys. Replace with
an original equipment belt.
7. To install a new belt, reverse the above
steps.
Screw
20
Belt Guard
Screw
Figure 18