Remote Control Commands - Defibtech Standalone AED Trainer User Manual

4 Remote Control Commands

The Remote Control can be used to change the behavior of the AED at any
time while the unit is powered on. The remote will have no effect on an AED
not configured as a trainer. The following functions can be performed using the
Remote Control keys:
• OFF - turns the AED off.
• PADS - simulates disconnected pads.
• NSR - simulates a Normal Sinus Rhythm (typically used once pads
have been applied to the training dummy).
• VFIB - simulates Ventricular Fibrillation (typically used once pads
have been applied to the training dummy).
• MOTION - simulates a cardiac rhythm corrupted with excessive
motion artifacts (typically used once pads have been applied to the
training dummy).
 -  - instantly changes the AED to the corresponding training
•
scenario.
VOLUME UP - increases the volume of the AED's voice
•
incrementally (up to a maximum limit).
• VOLUME DOWN - reduces the volume of the AED's voice
incrementally (down to a minimum limit).
• PAUSE - alternately suspends and resumes AED operation. Once
paused, the AED will only respond to the PAUSE key of the Remote
Control.

DAC-515E Rev. C