Toyota 3S-GTE Repair Manual page 120

EG-92
ENGINE — TURBOCHARGER SYSTEM
" M.
4
w'
I' '
x
TCCIO55
r'?
K U,
@' £ ' €
P182133
la
. L - '
"~.= ', '," -
e» ~
PINI3
\ ; .,\ .\.'\'?
\ »:' -1:3
'\ . = ; I
Y
~" (b)
PI83I2
)J O '
q ._ I
Q $35,211»
IIIUA—O\
TURBOCHARGER INSTALLATION
(See Components for Removal and Installation)
NOTICE: After replacing the turbocharger assembly,
pour approx. 2 cm' (0.12 cu in.) of fresh oil into the oil
Inlet and turn the impeller wheel by hand to spread oil on
the bearing.
INSTALL SIDE BEARING HOUSING PLATE
Install a new gasket and the housing plate with the 2
l'IU'I$.
Torque: 11.5 N-m (120 kgf-cm. 9 ft-Ibf)
INSTALL TURBO WATER PIPE
Install a new gasket and the water oipe with the 2
nuts and bolt.
Torque: 11.5 N-m (120 kgf-cm. 9 ft-Ibf) for nut
INSTALL TURBO OIL PIPE AND*OUi'I'LET PIPE AS-
SEMBLY
Align the oil holes of the a new gasket and the turbo-
charger housing.
Install the gasket and oil pipe with the 2 nuts.
Torque: 17 N-m (175 kgf-cm. 13 ft-Ibf)
INSTALL TURBOCHARGER
Place a new gasket on the turbocharger.
Install the turbocharger and turbo oil pipe assembly
with the 4 new nuts. Do not toroua the nuts.