Basic Operations - Returnstar Interactive Tech IQTOUCH User Manual

Install Remote Control battery
1. Insert two AAA batteries (7#, 1.5V) into the battery compartment.
2. Make sure that the battery match the +/– symbols are right connected.
3. Close the battery cover and make cover buckle into the housing.
Note: Direct the Remote Control to the devicereceiving place, any block between the Remote Control
and receiving place would hamper the operation.

Basic Operations

1) Power on/off
Connect the power plug to power outlet. Hold the "power" button on the device orthe Remote
Control to power on. Hold the "power" button again to power off the device.
2) Standby
Under power on mode, press the "power" button on the device or the Remote Control tochange to
standby mode.
3) Input selection
Press "Input" button on the device or Remote Controlto select input source,select the desired input by
Up/Down on the Remote Control or on the device
NOTE:
The device will be changed to standby mode automatically if you seta time switch.
Unplug this device when it will be unused for long periods of time.
5/10