AEG ARE H9 HF User Manual page 24

If the search was successful a selection of possible partners will be shown. The
Bluetooth partner search can't detect if a Bluetooth device supports the serial
port profile, the user has to know this. If the search was not successful the ARE
H9 HF switches back to the "Set Interface" menu.
After choosing a partner from the found devices, the ARE H9 HF will try to
establish a connection.
During this process the message "Await Connection" could appear when the
partner is not ready or at the partner side additional activities are necessary.
(Code 0000)
A successful connection will be shown as follows:
6.5.4 Bluetooth disconnect
If the connection to the Bluetooth partner is lost during the operating of the
ARE H9 HF, or maximum Bluetooth distance has exceeded, the following
display appears:
In this case will the ARE H9 HF wait as long as the connection is established
again ort he user cancels this screen by pressing both arrow buttons.
While switching off the ARE H9 HF the Bluetooth connection to a partner will
be automatically disconnected.
6.5.5 Set interface to HID Keyboard
If HID keyboard is selected as interface then every read transponder-ID will be
sent as keyboard input to a connected PC.
When HID-keyboard is selected the operating mode of the ARE H9 HF changes
automatically to the "Online/Keyboard" and there is no other "Mode of
Operation" available.
If there is a Bluetooth connection active, the ARE H9 HF closes this connection.
By pressing the left button in the standard display the reader sends "carriage
return" (13/0x0D).
---------------------------------------------------------------24/51---------------------------------------
Connected with
PC_007
Await Connection
Abort ?