External Requirement - calimax PWS 0601-A Operating Manual

6.3 External requirement

Activate external requirement (0/1)
Activate external analogue signal (0-10 V)
The respective modes are depicted in the display by the symbols 0/1 or 0-10 V if a signal is pending from
the external controls. By pressing the stop key, this mode can be interrupted at any time. The hand symbol
appears for manual mode.
External requirement (0/1) (EAB)
The external requirement allows the integration of
additional components which are equipped with a
potential-free switching contact (room thermostat).
Remove jumper EAB and connect bipolar connecting lead
of the external controls.
Applying voltage to the external
deactivation switch connector interferes
with the controls.
External analogue signal (+10 V - GND)
The external activator is used to tell the stove how much
heat to put out (input signal: 0 – 10 V
3V-30%...6V-60%...10V-100%
Applying voltages greater than 15 V
plug for the external activator interferes
with the controls.
12
).
DC
to the
DC