Daily Use - oticon Remote Control 3.0 Instructions For Use Manual

1. Prepare remote control
for pairing
Press and hold all buttons for 5 sec-
onds. The status LED will flash green
twice.
The status LED will then glow green
for about 10 seconds to confirm the
remote is ready for pairing.
12 About Startup Daily use Warnings More info
2. Put the hearing aids in
pairing mode
Ensure that you have good batteries
in the hearing aids.
Open the battery drawers of both
hearing aids. Wait about five seconds
and close the battery doors again.
Wait for about 10 seconds – until the
hearing aids are fully turned on and
the power-on-jingle has been played.
The hearing aids will remain in pairing
mode for 3 minutes.
3. Pair the remote control with the hearing aids
Place both hearing aids Briefly press any key on
within 20 centimetres the remote control to
of the remote control. make it automatically
pair with the hearing
aids.
When pairing is com-
pleted, the status light
glows green for about
10 seconds.
13