oticon Remote Control 3.0 Instructions For Use Manual page 16

The remote control contains a radio
transceiver using Bluetooth Low
Energy (BLE) and a proprietary short
range radio technology both working
at 2.4 GHz. The 2.4 GHz radio trans-
mitter is weak and always below 10
dBm e.i.r.p. in total radiated power.
The remote control complies with
international standards concerning
electromagnetic compatibility and
human exposure.
Due to the limited space available
on the remote control, relevant
approval markings can be found in
this document.
30 About Startup Daily use Warnings
USA and Canada
This device is certified under:
FCC ID: 2ACAHREMCTR03
IC: 11936A-REMCTR03
This device complies with Part 15 of
the FCC Rules and with Industry
Canada's licence-exempt RSSs.
Operation is subject to the following
two conditions:
1. this device may not cause harmful
interference, and
2. this device must accept any
interference received, including
interference that may cause
undesired operation.
More info
This Class B digital apparatus com-
plies with Canadian ICES-003.
Note: This equipment has been
tested and found to comply with
the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harm-
ful interference in a residential in-
stallation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to ra-
dio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to cor-
rect the interference by one or more
of the following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between
the equipment and receiver.
- Connect the equipment into an out-
let on a circuit different from that to
which the receiver is connected.
- Consult the manufacturer or an
experienced radio/TV technician
for help.
31