Water Hose - Husqvarna K970 II Ring Operator's Manual

• Fit the support roller cover. Now tighten the four
screws fully.
• Rotate the blade and make sure that the support
rollers are not clamped against the blade.
• Adjust the adjuster screws so that the support rollers
make contact against the blade.
• Adjust so you can easily stop the support rollers using
your thumb when the blade is rotated. The support
rollers should only follow the blade occasionally.
ASSEMBLING AND ADJUSTMENTS
• Tighten the locking nuts on the support roller guard.
• Rotate the blade and make sure you can still hold the
rollers with your thumb when the blade is rotated.
The machine shall stand upright when checking the
roll pressure. If the machine lies on its side the weight
of the blade makes it difficult to make a correct
adjustment.
• Tighten the knobs fully and the machine is ready to
use.
CAUTION! Incorrect adjustment can result in damage to
the blade.
If the blade rotates slowly or stops, stop cutting
immediately and trouble shoot.

Water hose

Connect the water hose to the water supply. The water
flow is activated by opening the check valve. Minimum
water flow: 4 l/min Note that the machine's hose nipple is
fitted with a filter.
–
English 11