Installation; Mounting The Fusion 70 Access Point - U4EA Fusion 70 Installation Manual

Installation

Installation
Prerequisites
The following are the prerequisites that you need to adhere to before
attempting to install the Fusion 70 Access Point:
For ease of cable connections, ensure that the access point is near a

hub or computer, as well as a reliable power source.
Ensure that the access point is away from any equipment that might

cause radio signal interference, such as transformers, radar, heavy-
duty motors, microwave ovens, refrigerators, or other.

Mounting the Fusion 70 Access Point

Do the following to mount an access point:
Find a solid mounting point on the wall, such as a stud or main
1.
building member. You may need to use a stud finder to find a solid
wooden structure.
Place marks on the wall that correspond to the distance between the
2.
mounting holes located on the mounting bracket. Use the following
guidelines:
Point the mounting bracket tabs upward.

If mounting to drywall, use the four screws and wall anchors.

If mounting to an EU electrical box (60.3mm), insert two screws

(included) into the holes marked "1" (shown below).
If mounting to a US electrical box (83.3mm), insert two screws

(included) into the holes marked "2" (shown below).
Connect the Ethernet cable (to use as either power and/or LAN
3.
connection) to the Ethernet port on the bottom of the AP.
If this is a PoE connection, the Power and Link LED flashes green.
8 001605, Rev. A