Desktop Mounting - U4EA Fusion 70 Installation Manual

Connect the power cable to the power connection located on the
4.
bottom of the AP.
The Power LED turns green as soon as power is applied.
Mount the AP using the mounting slots located at the bottom of the
5.
AP.
Note: You can also use the slots on the side of the AP if you cannot
mount the AP using the slots on the bottom of the AP.

Desktop Mounting

Do the following to place the AP on a table or desktop:
Insert the tabs on the table stand into the slots on the side of the AP.
1.
Align the cable routing cutout toward the upper part of the stand.
Lock the stand to the AP by sliding the stand back and forward.
2.
Place the AP on the table or desktop.
3.
Connect the Ethernet cable (for either power or LAN connection) to the
4.
Ethernet port on the bottom of the AP.
The Link LED flashes green when a LAN connection establishes.
Connect the power cable to the power connection also located on the
5.
bottom of the AP.
The Power LED turns green as soon as power is applied.
001605, Rev. A
Installation
9