Advertisement
ASSEMBLY
HOW TO SET UP YOUR TRACTOR
CHECK
BA'B'ERY
(See Fig. 2)
•
Lift seat pan to raised position.
•
If this battery is put into service alter month and year
indicated on label (label located between terminals)
charge battery foeminimum of one hour at 6-10 amps.
(See "BATTERY" in Customer Responsibilities ,s_'tJon
of this manual for charging inst--).
SEAT PAN
LABEL
FIG. 2
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjus_nent boll
•
Remove adjustment bait. lock washer and fiat washer
securing seat to cardboard pac_
and set aside for
assembly of seat to tractor.
•
Pivot seat upward and remove from the cardboard
packing. Remove the cardboard packing and discard.
•
Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
•
Push down on seat to engage shoulder bolt in ,slotand
pull seat towards rear of tram'tot.
•
Pivot seat and pan forward and assemble adjustment
bolt, Iockwasher and flatwasher loosely.Do not tighten
•
Lower seat into operating position and s_ton seat.
•
Slide seat untila comfortable position is reached which
allows you to press clutctVbrake pedal all the way down.
•
Get off seat without moving its adjusted position.
•
Raise seat and tighten adjustment bolt securely.
SHOULDER
BOLT
FLAT WASHER
LOCK WASHERs,
ADJUSTMENT
BOLT
FIG. 3
NOTE: YOU may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
7
Advertisement
