Advertisement
SERVICE AND ADJUSTMENTS
TO REPLACE
HEADLIGHT
BULB
ENGINE
•
Raise hood.
•
Pull bulb holder out of the hole in the backside of the grill.
•
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the gdll.
•
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged widng may cause your tractor to run
poody, stop running, or prevent it from starting.
•
Checkwidng. See electricalwidng diagram in the Repair
Parts section.
TO REPLACE
FUSE
Replace with20 amp automotive-type plug-in fuse. The fuse
holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 27)
•
Raisehood.
•
Unsnap headlight wira connector.
•
Stand in front of tractor. Grasp hood at sides, tilttoward
engine and lift off of tractor.
•
To replace, reverseabove procedure.
HOOD
HEADLIGHT
WIRE
CONNECTOR
TO
ADJUST
THRO'n'LE
CONTROL
CABLE
(See Fig. 28)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
descdbed below before loosening cable. If adjustment is
necessary, proceed as follows:
•
With engine not running, move throttlecontrollever from
slow to choke position. Slowly move lever from choke
to fast position.
•
Check that holes"A" in governor control lever and hole
in governor plate line-up. If holes =A" are not aligned,
loosen clamp screw and move throttlecable until holes
are aligned. Tighten clamp screw securely.
GOVERNOR
GOVERNOR
CONTROL
CONTROL
LEVER
PLATE
HOLES
"A"
CLAMP
THROTTLE
SCREW
CABLE
FIG. 28
RG. 27
TO ADJUST
CARBURETOR
The carburetor has been preset at the factory and adjust-
ment should not be necessary. However, minoradjustment
may be required to compensate for differences in fuel,
temperature, altitude or load. If the carburetor does need
adjustment, see engine manual.
High speed stop isfactory adjusted. Do not adjust- damage
may result.
IMPORTANT:
NEVER TAMPER WITH THE ENGINE
GOVERNOR, WHICH IS FACTORY SET FOR PROPER
ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE
THE
FACTORY
HIGH
SPEED
SETTING
CAN BE
DANGEROUS.
IFYOUTHINKTHE
ENGINE-GOVERNED
HIGH SPEED NEEDS ADJUSTING,
CONTACT YOUR
NEAREST
AUTHORIZED
SERVICE
CENTER/
DEPARTMENT, WHICH HAS PROPER EQUIPMENT AND
EXPERIENCE
TO
MAKE
ANY
NECESSARY
ADJUSTMENTS.
22
Advertisement
