Advertisement
SERVICE AND ADJUSTMENTS
REPLACING
BATTERY
(See Figs. 25 and 26)
WASHERS
R.AINING
"'"Q\ I\ llc* *. l l
SOUARE KEY (RF.N_ ......._-'
WHEEL ONLY)
"'"-
RG. 23
wristwatch bands, rings, etc.
TO START ENGINE WITH A WEAK BAI"rERY
(See Fig. 24)
I_
AUTION: Leed-edd batteries ganerato
[
explosive gases.
Keep sparks, flame
and smoking materials away from bat-
t_
Aivea_weareye l_vdNm
around batteries.
If your battery is too weak to start the engine, it should be
recharged. (See "BATTERY" in the Customer Responsibili-
ties section of this manual).
If "jumper cables" are used for emergency starting, follow
this procedure:
IMPORTANT: YOUR TRACTOR IS EOUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM.
THE OTHER
VEHICLE
MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM.
DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
•
Connect each end of the RED cat:detothe POSITIVE (+)
terminal ofeach battery, takingcare not to shortagainst
chassis.
•
Connect one end of the BLACKcable tothe NEGATIVE
(-) terminal of fully charged battery.
•
Connect the other end of the BLACK cable to good
CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
•
BLACK cable first from chassis and then from the fully
charged battery.
•
RED cable last from both batteries.
POSITIVE
TERMINAL
TERMINAL
POSITIVE
TERMINAL
BATTERY
•
Lift seat pan to raised position.
•
Disconnect BLACK battery cable first then RED battery
cable and carefully remove battery from tractor.
•
Install new battery with terminals in same positionas old
battery.
•
Firstconnect RED battery cable to positive (+) terminal
with hex bolt and keps nut as shown, Tighten securely.
Slide terminal cover over terminal.
•
Connect BLACK groundingcable to negative (-) terminal
with remaining hex bolt and keps nut.Tighten securely.
SEAT PAN
FIG. 25
TERMINAL
COVER
KEPS
NUT
HEX
PosmvE
NEGATIVE
(RED) CABLE
(BLACK) CABLE
FIG. 26
RG. 24
21
Advertisement
