Vision Fitness U60 Service Manual page 62

CHAPTER 9: SOFTWARE UPGRADE GUIDE
9.1 SOFTWARE UPGRADE INSTRUCTIONS - CONTINUED
4) After the first console installation is finished, you can remove the RS232 cable from the PC to MSP-GANG430 as shown in Figure D.
Upgrade the other consoles using MSP-GANG430 as shown in Figure E. Press the MSP430 Start button, the "MODE" LED will glitter for about
10 seconds. If the upgrade is complete, the OK green LED will light as shown in Figure F.
FIGURE D FIGURE E
FIGURE F
5) Install the console to the frame. Then pedal the bike to provide power to the console. Enter into Manager Mode (see Section 5.1) to confirm
that the software had been installed / upgraded correctly. Also check to make sure that the Machine Type is correct.
6) Test the bike for function as outlined in Section 7.20.
59