Whirlpool DDLX 70113 Health & Safety, Use & Care And Installation Manual page 7

The dryer is not designed for
built-in installation .
The dryer can be installed
under a worktop, provided
that adequate ventilation of
the dryer is assured . Install
a ventilation grid (minimum
45 cm x 8 cm), in the rear part
of the worktop under which
the dryer is installed .
ELECTRICAL WARNINGS
Make sure the voltage specified
on the rating plate corresponds
to that of your home .
For installation to comply with
current safety regulations,
an omnipolar switch with
minimum contact gap of 3 mm
is required .
Regulation require that the
dryer is earthed .
For dryers with fitted plug,
if the plug is not suitable for
you socket outlet, contact a
qualified technician .
Do not use extension leads,
multiple sockets or adapters .
Do not connect the dryer to a
socket which can be operated
by remote control .
The power cable must be
long enough for connecting
the dryer, once fitted in its
housing, to the main power
supply .
Do not pull the power supply
cable .
If the power cable is damaged
it must be replaced with an
identical one . The power
cable must only be replaced
by a qualified technician
in compliance with the
manufacturer instruction and
current safety regulations .
Contact an authorized service
centre .
Do not operate this dryer if
it has a damaged mains cord
or plug, if it is not working
properly, or if it has been
damaged or dropped . Do not
immerse the mains cord or
plug in water . Keep the cord
away from hot surfaces .
The electrical components
must not be accessible to the
user after installation .
Do not touch the dryer with
any wet part of the body
and do not operate it when
barefoot .
ELECTRICAL CONNECTION
FOR GREAT BRITAIN AND
IRELAND ONLY
Fuse replacement.
If the mains lead of this dryer is
fitted with a BS 1363A 13amp
fused plug, to change a fuse in
this type of plug use an A .S . T .A .
approved fuse to BS 1362 type
and proceed as follows:
1 . Remove the fuse cover (A)
and fuse(B) .
2 . Fit replacement 13A fuse into
fuse cover .
3 . Refit both into plug .
Important:
The fuse cover must be refitted
when changing a fuse and
if the fuse cover is lost the
plug must not be used until a
correct replacement is fitted .
Correct replacement are
identified by the colour insert
or the colour embossed in
words on the base of the plug .
Replacement fuse covers
are available from your local
electrical store .
For the Republic of Ireland
only
The information given in
respect of Great Britain will
frequently apply, but a third
type of plug and socket is also
used, the 2-pin, side earth
type .
Socket outlet / plug (valid for
both countries)
If the fitted plug is not suitable
for your socket outlet, please
contact After-sales Service for
further instruction . Please do
not attempt to change plug
yourself . This procedure needs
to be carried out by a qualified
technician in compliance with
the manufactures instructions
and current standard safety
regulations .
CORRECT USE
Do not exceed the maximum
load allowed . Check the
maximum load allowed in the
programme chart .
Do not dry unwashed items in
the tumble dryer .
Do not overdry the laundry .
Take care that no lint or dust is
accumulated around the dryer .
Fabric softeners, or similar
products, should be used as
specified by the fabric softener
instructions .
EN
7