USER’S MANUAL Bottom-Load Water Cooler MODEL NO. CLBL420 Thank you for purchasing a Lago water cooler. Please read this user’s manual thoroughly for using the water coolers safely and appropriately.
SAFETY PRECAUTIONS • Plug in the dispenser in the way described in this manual. • In accordance with these instructions, the dispenser must be properly located and installed before use • Use only water. Do not use co ee, tea or other beverages. •...
Hot, Cold, & Room Faucets Hot | Room | Cold Press the button on the right for Cold Water, middle for room temperature water, & left button for hot water. Place a cup directly below a faucet and depress the correct lever, but be careful using the hot water. Even when a bottle is empty, Cold Water is available, for a small volume, but hot water is not available when the bottle is empty.
Remove the Air inside the Hot Water Tank After installing a bottle, remove the air inside the Hot Water Tank by pressing and holding the Hot Water Lever as shown in the following gure until water starts to come out of the water outlet.
TROUBLESHOOTING Please check the following items prior to asking for repair Troubles Things to check Troubleshooting Is the bottle empty? Replace with a new bottle. Water does not come out (Cold Water & Hot Water) Is the air inside the Tank removed Press and hold the lever until the water completely? comes out through Hot Water Faucet.
About 1.1ℓ (Stainless Steel Tank) * For the improvement of product Brio reserves the right to change specifications without notice. * You must confirm the correct voltage(V) and frequency(Hz) and then plug to the outlet. Check the proper voltage in the back of dispenser.