Safety Information WARNING: To reduce risk of injury and property damage, you must read this entire guide before assembling, installing, and operating the dispenser. WARNING: This product dispenses water at very high temperatures. Failure to use properly can cause personal injury. When operating this dispenser, always exercise basic safety precautions, including the following: •...
Intended Use This dispenser is intended to be used in household and similar applications such as: • Staff kitchen areas, offices, and other working environments • Hotels, motels, and other residential-type environments • Bed-and-breakfast type environments • Catering and similar non-retail applications This dispenser is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Touch Panel Description 1� Child safety lock button – Press to lock the hot water button and prevent children from dispensing hot water. 2� Hot water button – Press and hold to dispense hot water. Release the button when your container is full. 3�...
Installation 1� Determine Installation Location IMPORTANT: If the unit has been resting on its side for a long period of time, place the unit in the upright position for approximately 12 hours before turning it on. A� Place the dispenser upright, on a hard and level surface. B�...
I� Turn the drain valve clockwise to close the drain, then throw away the drained water. J� Fill a clean bucket with 8 cups (2 liters) fresh, hot water and repeat steps C–I. 4� Connect a Water Bottle IMPORTANT: To prevent dry heating, do NOT turn on the hot water activation switch until you complete the steps in this procedure.
Operation IMPORTANT: This unit has been tested and sanitized prior to packing and shipping. During transit, dust and odors can accumulate in the tank and lines. Dispense and dispose of at least 1 quart of water prior to drinking any water. Turn the Dispenser On/Off IMPORTANT: Before you turn the dispenser on and activate the hot and cold switches, ensure a bottle is...
Change the Water Bottle CAUTION: Do NOT dispense hot, room temperature, or cold water if the red light is flashing. You could empty the tanks and cause the dispenser to overheat. When the bottle indicator light behind the front logo illuminates, it is time to refill your water bottle: 1�...
Troubleshooting Guide Refer to the table below for symptoms, possible causes, and solutions. Problem Solution • It takes approximately 1 hour after setup to dispense cold water. • Make sure the power cord is properly connected to a working outlet. •...
Warranty Brio (“Vendor”) warrants to the original purchaser of the Brio Water Coolers (the “Product”), and to no other person, that if the Product is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in the Product shall be free from defects in material and workmanship.