Check List - Dometic RHC 460 Instructions For Use Manual

5.4

Check List

Failure : No cooling (the aggregate at the back of the device is cold).
Possible Cause
a.) The thermostat is set to "0".
b.) The device plug is not
plugged in.
c.) No voltage in socket.
Failure : No cooling (the aggregate is warm).
Possible Cause
a.) The device was only
switched on a short while ago.
b.) Defective cooling aggregate.
Failure : Poor Cooling Performance.
Possible Cause
a.) The cooling aggregate is not
sufficiently ventilated.
b.) The fridge door does not
close tightly.
c.) Light permanently on when
door closed.
d.) The fridge was stocked a
short while ago.
Failure : Frost formation in fridge.
Possible Cause
a.) The fridge door does not
close tightly.
Self Help
a.) Set temperature control to
middle position.
b.) Plug in device plug.
c.) Check building fuse..
Self Help
a.) Switch on the device and
let it run for 1 hour.
Self Help
a.) Check that the ventilation
grilles are not covered. Check
that device has been installed
properly (installation instruction
4.5)
b.) Check installation in line
4.5.
d.) Check fridge after 1 hour
for proper cooling.
Self Help
a)Check installation in line 4.5. a.) Is door magnet
10
Authorised Service
Authorised Service
b.) Exchange fridge
Authorised Service
b.) Is door magnet
there? Install new door,
if required.
c.) Replace lighting
sensor. Install new door,
if required.
Authorised Service
there? Install new door,
if required.