Record DFA 127 Operating Instructions Manual page 19

Status and fault signals
Status 60:
Status 61:
Status 62:
Status 72:
Status 88:
Status 89:
Status 90:
Status 91:
Status 92:
Status 93:
Status 94:
Status 95:
Status 96:
Status 99:
Status 105:
Operating instructions DFA 127 Full Power
Parameter memory (EEPROM) defective
Change control unit
Reset by service fitter
SSK active longer than 60 s
Automatically reset if in order, or by service fitter
BDE has no priority
Because a higher-level signal is present
Automatically reset on release of BDE-button
Slave connection
Master has no connection to Slave operator
Reset by service fitter
Difference parameter
The common parameters of M/S operators do not correspond to
each other.
Reset by service fitter
Master connection
Slave has no connection to master operator
Reset by service fitter
Railbeam active > 60 sec.
Automatically reset if everything is in order, or by service fitter
Bodyguard active > 60 sec.
Automatically reset if everything is in order, or by service fitter
STG relay defective
Replacement by service fitter
Overvoltage 24 V (from 27V)
Spring calibration
Automatic reset
Error in sense of rotation
EEPROM void
Operator rotates
The grease in the gear will be dispersed.
Automatic reset
Test brake
Automatic reset
Rev. B 11/2006 Page 19 of 20