Download Print this page

Record HA8-LP Setup & Quick Start Manual

Low-energy door operator

Hide thumbs Also See for HA8-LP:

Download this manual

Record HA8-LP

Low-Energy Door Operator

Mechanical Setup Quick Start Guide

www.recorddoors.com

Need help?

Do you have a question about the HA8-LP and is the answer not in the manual?

Page 1 Record HA8-LP Low-Energy Door Operator Mechanical Setup Quick Start Guide www.recorddoors.com...
Page 2 Record HA8-LP Low-Energy Swing Door Operator Recommended Tools Item Description Item No. Description Allen Wrench Set Flat Screwdriver, Philip Screwdriver, 5/16” Hex. Nut Driver Power Drill and Drill Bits Additional Fasteners Depending on Surface Level Shims Tape Measure Hand Saw/Power Saw...
Page 3 Record HA8-LP Handing Chart • left-push-surface r·ight-push-surface • Ieft-pu11-surfoce right-pul I-surface...
Page 4 Installation of the Back Plate • • • • •...
Page 5 Installation of the Back Plate Figure 4 Figure 5 shims Figure 6 • •...
Page 6 Installation of Power and Motor/Gearbox...
Page 7: Installation Of Control Board
Installation of Control Board Figure 11...
Page 8 Installation of Push Arm 14”...
Page 9 Installation of Push Arm Note: Inspect that arm is not binding or rubbing on door. Keep ARMS level during installation. External door or floor stop is required. Do not use ARM as door stop.
Page 10 Installation of Pull Arm D oor Shown Op e n Step 17] Pull Arm Toggle hold open button on end cap Verify that pinion output shaft turns in the right direction Figure 12 , r - When spindle stops, open the door and MARK THE POSITIONWHERE THE ROLLER TOUCHES THE DOOR connect main arm to spindle output...
Page 11 Signage ± ±...
Page 12 Mechanical Installation Complete Next Step - See Control Board Setup...