Main Menu; Temperature Settings; Installer Status Screen; Week Program - Frico SIRe AC Quick Manual

Main menu

Current settings
Current set values.

Temperature settings

Day/night temperature. The night
temperature is only valid when the week
program is activated.
Installer menu
Password 1932

Installer status screen

Current settings and functions.

Week program

Activate week program, check, change, add or
erase program.
Fan settings
Fan control and over run functions.
Heating settings
Set point difference open door, (calibrating
sensors).

Alarm and error codes

Reset alarm
Note! Before resetting, check that the fault is rectified
and there is nothing to prevent the unit from being
recommissioned.
Press and select reset alarm.
At the first start up alarm and error codes
can occur, these will usually be reset without
actions.
Complete manual see www.frico.se
SIRe Competent
Fan control
Maximum fan speed and fan speed when the
door is closed. Fan speed when the door is
closed is only valid when using SIReAC.
Summer/Winter
Summer - heat off
System on/off
Safety features are still active when the
system is switched off.
Filter guard settings
Activate filter timer and set service interval.
External control (BMS)
External on/off, fan control 0-10V. See
"Connecting external control".
General settings
Language, time, date, function test, manual
system check and factory reset.
Support menu
The support menu is password protected and
is used for support in contact with Frico or
authorised installer.
Power failure
Note! A power loss longer than 7 days may
require an adjustment of time and date.
The week program is affected if the clock is
not correctly set.
GB
27