General - Husqvarna P524 Operator's Manual

All lubrication points
6
4
1 Bearing unit - rear axle
2 Link brace
3 Articulated Bearing
4 Bearing unit - front axle
5 Steering cylinder
6 Axle for lifting chain
34 –
English
Lubrication
3
1
4
1 1
2
5

General

Remove the ignition key to prevent unintentional movements
during lubrication.
When lubricating with an oilcan, it ought to be filled with engine
oil.
When lubricating with grease, unless otherwise stated, grease
503 98 96-01 or another chassis or ball bearing grease offering
good corrosion protection shall be used.
If the machine is used daily it should be lubricated twice a week.
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the belts or the drive
surfaces on the belt pulleys. Should this happen, attempt to
clean them with spirits. If the belt continues to slip after cleaning
with spirits, it must be replaced.
Petrol or other petroleum products must not be used to clean
belts.