Storage; Winter Storage; Guard; Service - Husqvarna P524 Operator's Manual

Hide thumbs Also See for P524:
Table of Contents

Advertisement

Winter storage

At the end of the season, or if the machine is going to stand
idle for more than 30 days, it should immediately be made
ready for storage. Fuel which is left to stand for long periods
(30 days or more) can leave sticky deposits and interfere with
the engine function.
Fuel stabiliser is an acceptable alternative to avoid tacky
deposits during storage. If alkylate petrol (Aspen) is used
stabiliser is not necessary since this fuel is stable. However,
one should avoid changing from standard to alkylate petrol
since sensitive rubber parts can harden.
Add stabiliser to the fuel in the tank or the storage container.
Always use the mixing ratios indicated by the manufacturer.
Run the engine for at least 10 minutes after adding the
stabiliser. Do not empty the fuel tank and carburettor if
stabiliser has been added.
WARNING! Never store a machine with fuel
!
in the tank indoors or in poorly ventilated
spaces where fuel vapour can come in
contact with open flames, sparks, or a pilot
light such as in a boiler, hot water tank,
clothes drier, etc. Exercise caution when
handling fuel. It is highly inflammable, and
careless use can cause serious injury and
damage to property. Drain off the fuel in an
approved container outdoors and well clear
of naked flames. Never use petrol for
cleaning purposes. Use degreasing agents
and hot water instead.
To prepare the machine for storage follow these instructions:
1 Carefully clean the machine, especially under the cutting
unit. Touch-up paint damage to avoid rust.
2 Inspect the machine for worn or damaged parts and
tighten loose screws and nuts.
3 Change the engine oil, and take care of the waste oil.
4 Empty the fuel tank. Start the engine and run it until the
carburettor is emptied of fuel.
5 Remove the plugs and pour about a tablespoon of engine
oil into each cylinder. Pull round the engine to distribute
the oil and screw the plugs back on.
6 Grease all grease nipples, joints and axles.
7 Remove the battery. Clean it, charge it, and store it in a
cool place.
8 Store the machine in a clean and dry place and cover it
over for extra protection.
40 –
English

Storage

Guard

There is a cover to protect your machine during storage or
transport. Contact your dealer for a demonstration

Service

Low season is the most suitable time to perform a service or
overhaul of the machine in order to ensure high function
safety during high season.
When ordering spare parts state your machine's purchase
year, model, type, and serial number.
Always use genuine parts.
An annual check-up by an authorised servicing dealer is a
good way to ensure that your ride-on mower performs at its
best the following season.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents