Husqvarna P524 Operator's Manual page 20

Lubricate the hydrostatic cable with links
Check the parking brake
Lubricate the parking brake wire
Lubricate throttle control
Lubricate choke control
Lubricate the chain in the frame tunnel
Check the V-belts
Checking the transmission oil level
Checking and adjusting the choke wire
Tighten the nuts and screws
Checking and adjusting of throttle wire
Replace the fuel filter.
Replace the spark plug.
Replace the engine oil filter
Check/adjust front and rear wheel rotation
speed according to the service schedule
1)
If the machine is used daily it should be lubricated twice a week.
X = Described in this operator's manual
O = Not described in this operator's manual
IMPORTANT! When the machine is in operation the hoses are under high pressure. Do not try to connect or disconnect the hoses
when the hydraulic system is operational. This can result in serious personal injuries.
WARNING! No service procedures must be conducted on the engine or cutting unit unless:
!
The engine is switched off.
The parking brake is applied.
The ignition key is removed.
20 –
English
Maintenance
X
X
4)
2)
Conducted by authorised service workshop.
X
X
X
X
X
O
X
X
O O
X
O
O
X X
X X
O O O