Connecting Pelco-Keyboard (Kbd200A/Kbd300A) - ECOLINE TV7094 Installation Instructions Manual

Connecting PELCO-keyboard (KBD200A/KBD300A)

Connect the RS-422 serial port (terminal TX +) from the control keyboard, to the Speed Dome
Camera RS-485 serial port (terminal D +). And connect the RS-422 serial port (terminal TX
-) from the control keyboard, to the Speed Dome Camera RS-485 serial port (terminal D -).
Normal Display Mode
Speed Dome Function
Focus Near
Focus Far
Iris +
Iris -
Pan Left
Pan Right
Tilt Down
Zoom Tele
Zoom Wide
OSD Setup Menu Mode
Speed Dome Function
Cursor Up
Cursor Down
Menu Enter
Menu Exit
Decrease (-)
Increase (+)
Speed Dome Function
Accessing Main Menu
Call up the Preset Points
Setting the Preset Points
AUTO SCAN
STOP SCAN
Call up Preset AUTO PAN
Stop Preset AUTO PAN
Please refer to PELCO Keyboard (KBD200A/ KBD300A) manual for more information.
Tilt Up
None
None
None
None
PELCO Keyboard
Move Joystick Left
Move Joystick Right
Move Joystick Up
Move Joystick Down
Twist Joystick clockwise
Twist Joystick counterclockwise
PELCO Keyboard
Move Joystick Left
Move Joystick Right
Move Joystick Up
Move Joystick Down
Twist Joystick clockwise
Twist Joystick counterclockwise
PELCO Keyboard Operation
Enter 95; Hold the PRESET key (approximately
five seconds) until the main menu appears on
the screen.
Enter preset number (1~32, 35~82) and press
PRESET to put camera in preset position.
To program, position camera, enter desired
preset number (1~32,35~82), and hold down
PRESET for two seconds.
Enter 99 and press PRESET
Enter 96 and press PRESET
Enter group number (1~6) and press PATTERN
Press ACK
26
NEAR
FAR
OPEN
CLOSE
NEAR
FAR
OPEN
CLOSE