Table of Contents
Advertisement
Back panel terminals
(1)
Power 12VDC
(2)
RS-485 terminal
(3)
RJ-485 / RJ-11
System installation
The system supports connections of
numerous Speed Dome Cameras or
P/T/Z Receivers, assigning a set ID
(Note! ID numbers ranges from
1~127 and may not be repeated)
for
setup
and
control,
control keyboard
Connecting RS-485
Connect RS-485 terminal D+ from
the control keyboard to terminal D+
of RS-485 DATA IN connector from
the device; then connect RS-485
terminal
D-
(the
terminal) to the terminal D- of RS-485
DATA IN connector from the device.
(1
(2
)
)
Connect a 12VDC, 1,5A power source.
To connect the 2 wires communication control cable to the speed
dome
D+D- D+D-
Alternatively you can connect the dome via the RJ-11 connector.
through
same
set
of
(3
)
Keyboard
14
Monitor
Advertisement
Table of Contents
