Speaker Wiring - DLS DD31T Owner's Manual

REMOTE LEVEL Controller Connection
Your DLS DD31T amp includes a Remote Level control module. To connect the Remote Level Control to the amplifier,
simply insert one end into the REMOTE LEVEL port. Plug the other end into the remote module. Install the module within
easy reach on or under your dash.
Speaker Load
Keep in mind your DLS DD31T amplifier is a high power amplifier and not a high current amplifier. In other words this
amplifier requires a minimum impedance of 2 ohms STEREO and 4 ohms bridged (2-ohms MONO on SUB channel)
to operate trouble free Lower. impedance will send the amplifier into protection and possibly damage the electronics inside
and void the waranty.
NOTE: Know your total impedance load before you make any connections.

Speaker Wiring

Choose the correct speaker wire for your application. Most applications will require a minimum of 16 gauge wire. At the amplifier
end, splice the speaker wires to the properly marked output leads from the Molex style connector. Route these using the same
precautions as you did when you ran the power cable. Check to make sure you've maintained proper polarity and balance.
Maintaining proper impedance is critical when wiring the Full Range Digital model amplifiers. Improper wiring can cause
severe damage to BOTH the speakers and the amplifier. Detailed wiring diagrams are supplied with all DLS woofers. IF
YOU ARE NOT EXPERIENCED OR UNCOMFORTABLE READING THE WIRING DIAGRAMS CONSULT YOUR
AUTHORIZED DLS DEALER BEFORE YOU ATTEMPT TO WIRE THE SYSTEM.
SPEAKER WIRING AND CONFIGURATIONS
CAUTION:
Fig.11 Connection with RJ12 Jack