Table of Contents
Advertisement
Speaker wiring CA 10
One 4 ohm subwoofer
4 ohm load
Speaker
+
+
Filter settings
Subsonic
Off On
The Subsonic filter in ON-position and the LPF fil-
ter setting at 60-80 Hz.
Four 4 ohm subwoofers
1 ohm load
Speaker
+
+
6
-
-
LPF
40Hz 125Hz
-
-
Two 2 ohm subwoofers
2 ohm load
Speaker
+
+
Testing
Before you finish the installation, you should do the
following tests to make sure the wiring is correct and
everything is operating properly.
Reconnect Battery
When wiring is complete,
reconnect the battery
negative terminal.
Test power wiring
1.
Turn on the head unit but do not turn up the
volume. The amplifier power light should
come on. If not, check the remote and +12
volt wires. Also check the ground
connection.
2.
Turn up the head units volume slightly. All
speakers should operate. if not, check wiring
connections at amplifier and speakers.
Test speaker connections
Make sure the speakers are connected right. Use
the balance control on the head unit to make sure
right channel is on right speaker etc. If speakers
don´t play at all, one or both speaker wires may
be disconnected.
CA10
-
-
Advertisement
Table of Contents
