Carbolite Gero 3508 Installation, Operation And Maintenance Instructions page 16

3.0 3508 Controller
Ramp Units
These apply to Rate segments only. Press scroll until the display shows 'Ramp Units'.
Press up or down
Number of program cycles
Press scroll until the display shows 'Cycles'. Press up
than one cycle.
Now create all the segments for your program, finishing with an 'End' segment. When
parameters for each segment have been entered the display goes to the next segment
number.
Segment Type
Press scroll until the display shows 'Segment Type'. Press up
'Rate', 'Time', 'Dwell', 'Step', 'Wait', 'GoBack', 'Call' or 'End'.
Holdback Type
Press scroll until the display shows 'Holdback Type'. If required, press up
to select 'Off', 'Low', 'High' or 'Band'.
Target Setpoint (Visible only for Rate, Time and Step segments)
Press scroll until the display shows 'Target SP'. Press up
Ramp Rate (Visible only for Rate segments)
Press scroll until the display shows 'Ramp Rate'. Press up
number of degrees per 'Ramp Unit' as set above.
Duration (Visible only for Time and Dwell segments)
Press scroll until the display shows 'Duration". Press up
Wait For (Visible only for Wait segments)
Press scroll until the display shows 'Wait For'. Press up
PrgIn1, PrgIn2, PrgIn1In2, PrgIn1orIn2, PVWaitIP.
GoBack to segment number (visible only for GoBack segments)
Press scroll until the display shows 'GoBack Seg'. Press down
number to go back to.
GoBack Cycles (visible only for GoBack segments)
Press scroll until the display shows 'GoBack Cycles'. Press up
value.
16
to select the ramp units of degrees per Hour, Min or Sec.
or down to select more
or down
or down to set a value.
or down to set the
or down to set a value.
or down to select:
to select a segment
or down
to select
or down
to set a