Cable Connection; Usb Interface; Connecting Your Gcc Cutter; Serial Interface Connector (Rs232C) – - GCC Technologies Jaguar J5-61 User Manual

2.8 Cable Connection

The cutting plotter communicates with a computer through a USB (Universal Serial Bus), a
Serial port (RS-232C) or Ethernet. This chapter shows you how to connect the cutting plotter
to a host computer and how to set up the computer/cutting plotter interconnection.
!! Notice: When USB connection is enabled, serial port will be disabled automatically.
Figure 2-25

2.8.1 USB Interface

Jaguar V build-in USB interface are based on the Universal Serial Bus Specifications Revision
2.0 (Full Speed).

2.8.1.1 Connecting your GCC cutter

1. Turn on the machine.
2. Connect the USB connector to the machine and then USB driver will installed
automatically. It will take a few minutes to find the device. Please DO NOT disconnect the
USB cable until the installation has completed.
3. You can double click the USB icon on the taskbar to make sure the USB device is
detected.
Installation
Serial Interface Connector (RS232C) –
used to connect the cutting plotter to a
computer through a serial interface cable.
Ethernet Connector– used to connect your
computer to a local area network.
USB Connector
–
plotter to a computer through a USB cable.
2-17
Jaguar V User Manual
used to connect the cutting