Print In Color - Rimage prism III User Manual

Set your Printing Preferences
7. Select Yes or No under the Double Print option. The default is No.
Tips:
• If you select Yes under the Double Print option, the printer will print
each disc twice to darken the image.
• The Double Print option is only available for monocolor printing.
8. Select Yes or No under the Detect Media Change option. The default is
No. Retain the default setting for AutoPrinter or AutoLoader use.
Tip: If you select Yes, the printer will wait for the user to change the disc
before printing another disc.
9. If you have a standalone Prism III printer, disable the Perfect
Print option. The Perfect Print option is only available on Rimage
AutoPrinters.
Tip: Refer to the Rimage AutoPrinter user guide for more information on
the Perfect Print option.
10. Select OK to save the changes and close the Device Settings window.

Print in Color

1. Install a multicolor ribbon in the printer. Refer to the
Ribbon
section on page 18.
Tip: The print color is automatically detected and set based on the type
of ribbon installed in the printer.
2. Access Print Properties. Refer to page 9.
3. Select the Device Settings tab.
4. Select Halftone Setup Properties to make changes that affect color
intensity, color balance, or pattern settings.
2001809_A
SHORT TERM CONFIDENTIAL
5. Select Media Type.
6. Set the Master Print Strobe. Refer to the
7. Enable Color Sub-Strobes. Refer to the
8. Select Yes or No under the Detect Media Change option. The default is
9. If you have a standalone Prism III printer, disable the Perfect
Change the Print
10. Select OK to save the changes and close the Device Settings window.
For more information visit rimage.com/support
Tip: Some DVD media has a raised stacking ring on the printable side of
the disc. The direct thermal print process used in the Prism III printer
cannot print in this area. The DVD with Top Stacking Ring setting causes
the printer to skip over the stacking ring which results in an unprinted
band on the disc. Rimage recomends using discs without the stacking
ring on the printable surface.
more information.
information.
Important! Color Sub-Strobes are only available with CMY ribbons and
are disabled by default. The Master Print Strobe has no effect when
Color Sub-Strobes are enabled.
No.
Tip: If you select Yes, the printer will wait for the user to change the disc
before printing another disc.
Print option. The Perfect Print option is only available on Rimage
AutoPrinters.
Tip: Refer to the Rimage AutoPrinter user guide for more information on
the Perfect Print option.
Strobe Settings section for
Strobe Settings
section for more
13