Update The Firmware; Set Device Settings For Monochrome Or Cmy Ribbons; Print In Monocolor; Short Term Confidential - Rimage prism III User Manual

Set your Printing Preferences

i. If the lines cross the horizontal and vertical scales at 0, no
adjustment is needed. Press OK.
d. If at least one line crosses away from 0, enter the horizontal and
vertical correction factors read from the disc. Select Save Settings.
2001809_A

SHORT TERM CONFIDENTIAL

Update the Firmware

1. Access Print Preferences. Refer to page 9.
2. Select the Service tab.
3. Select Service Toolbox. The Service Toolbox dialog box opens.
4. Select Update Firmware.

Set Device Settings for Monochrome or CMY Ribbons

You can print in one (monocolor) or more colors. Use these procedures to
set up the Prism to print in color or monocolor and adjust device settings for
the type of ribbon used.

Print in Monocolor

1. Install a monocolor ribbon in the printer. Refer to the
2. Access Print Properties. Refer to page 9.
3. Select the Device Settings tab.
4. Select Halftone Setup Properties to make changes that affect color
5. Select Media Type.
6. Set the Master Print Strobe. Refer to the
For more information visit rimage.com/support
Update Firmware for the Rimage Prism III Printer
Tip: Refer to the
document for more information on updating your firmware version.
Ribbon
section on page 18.
Tip: The print color is automatically detected and set based on the type
of ribbon installed in the printer.
intensity, color balance, or pattern settings.
Tip: Some DVD media has a raised stacking ring on the printable side of
the disc. The direct thermal print process used in the Prism III printer
cannot print in this area. The DVD with Top Stacking Ring setting causes
the printer to skip over the stacking ring which results in an unprinted
band on the disc. Rimage recomends using discs without the stacking
ring on the printable surface.
more information.
Change the Print
Strobe Settings
section for
12