JBL On Air Wireless Owner's Manual page 11

settIngs
Selecting "Settings" on the Main Menu screen displays the Settings
Menu screen:
This screen lets you configure your JBL On Air Wireless to operate the
way you want it to.
alarms
Selecting "Alarms" displays the main Alarms screen:
This screen shows your current alarm settings and lets you change the
alarm settings. Active alarms are indicated by a check mark.
To set an alarm, press the Center Soft (Edit) button. The JBL On Air
Wireless will display the Alarm Settings menu screen. When you're
finished setting the alarms, press the Right Soft (Save) button to save
the settings.
Use the Up, Down, Left, Right and OK buttons to adjust the following items:
• alarm time: Set the time you want the alarm to sound.
• repeat: Set the alarm to repeat every day, weekdays only or
weekends only, or turn the alarm off.
• sound: Set the alarm to wake you with a buzzer, FM radio or your
iPod/iPhone device. NOTE: If you select "iPod" and your iPod device
is not docked at the time the alarm is set to ring, the buzzer will
sound.
• Volume: Set how loud you want the alarm to sound.
• Volume ramp: Selecting "Off" ramps the alarm from silence up to
your pre-determined alarm volume over a period of three seconds.
Selecting "On" ramps the alarm from silence up to your pre-
determined alarm volume over a period of three minutes.
turning the alarm sound off:
• Press the Snooze button momentarily to shut the alarm sound off.
After nine minutes, the alarm will sound again.
• On the unit, press and hold the Snooze button for three seconds
(on the remote control, press the Alarm Off button) to shut the alarm
sound off until the next time the alarm is scheduled to ring.
www.jbl.com 11