Important Safety InStructIonS Read these instructions. Only use attachments/accessories specified by the manufacturer. Keep these instructions. Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Heed all warnings.
Page 3
Industry Canada Statement: This Class B digital apparatus streaming to the JBL On Tour iBT. When you’re ready to go, snap the stand right to the JBL On Tour iBT unit complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 for easy and convenient transport.
General Setup The JBL On Tour iBT portable loudspeaker is a complete two-channel audio system in one easy-to-place Unpack the JBL On Tour iBT system and its power supply. footprint. The JBL On Tour iBT loudspeaker delivers sound with a powerfully tuned digital audio path.
Place (4) fresh AA batteries as shown. Replace the battery compartment cover. Before you can use your JBL On Tour iBT system with a Bluetooth-enabled device, you must pair it with that device. Note: The JBL On Tour iBT will not use battery power when using AC power.
Page 6
Press either Volume button on the JBL On Tour iBT unit. deVIce Make sure the JBL On Tour iBT speaker is paired (see Bluetooth Pairing section, on page 5). When you hear your Bluetooth-enabled device’s ringtone from the JBL On Tour iBT system, press the MFB “...
JBL On Tour iBT’s auxiliary 3.5mm mini jack. To cycle through the sources, make sure the JBL On Tour iBT is not in the Bluetooth call mode and momentarily press the MFB “ ” button. Each press of the button changes to the next source. The source...
Page 8
JBL On Tour iBT’s MFB “ ” button repeatedly until the Source LED lights Green. This indicates that the Aux input source is selected. You can easily snap the tabletop stand on and off the JBL On Tour iBT for convenient storage or transport. Control music playback through the auxiliary device.
Source ledS SpecIfIcatIonS The Power and Source LED colors change to indicate the state of JBL On Tour iBT unit. Transducers 4 x JBL Odyssey Amplifier 2 x 8 watts at 1% THD Frequency response 100Hz – 20kHz Signal-to-noise ratio >85dB...
Page 10
There is no sound from your JBL On Tour iBT speaker. There is no power to the unit. Make sure the wall power outlet or power strip has Is the Power LED glowing green? If the power;...
Page 11
There is too much bass or treble. The JBL On Tour iBT system is being overdriven by an Ensure that the JBL On Tour iBT system is connected to an amplified audio source. appropriate source device.
Page 12
The iPod battery is low. Charge the JBL On Tour iBT system by following the If the amber LED on the JBL On Tour iBT unit is battery charging directions in this Owner’s Manual. on, it is indicating a low battery.