Required Tools And Parts - Cisco 1003 User Manual

Installing Your Cisco 1003 or Cisco 1004 Router

Required Tools and Parts

Following are the tools and parts required to install your router:
•
A 3/16-inch (0.476 cm) flat-blade screwdriver or socket screwdriver
•
Wall-mount hardware, including screws, which you must provide
•
A console cable (RJ-45-to-RJ-45)
•
RJ-45-to-DB-25 adapter, for use with the console cable
•
One interface cable for the LAN port (10BaseT Ethernet)
•
One interface cable for the BRI ISDN (WAN) port
•
An NT1 device for access to an ISDN through the BRI port (Cisco 1003 only)
The ISDN service provider provides the NT1 connection worldwide, except in North
America, where the NT1 device is supplied by the customer. The Cisco 1004 router
contains an integrated NT1 device. If you have a Cisco 1003 router, a separate NT1 device
is required.
The router can be placed on any flat surface or installed in any orientation, such as upside
down or on a vertical surface. The router is designed to allow trouble-free operation without
cooling fans, special equipment closets, or racks.
To avoid the possibility of the cables becoming disconnected, install your router in a
manner that minimizes strain on the cables.
Setting Your Router on a Desktop
Caution
could restrict airflow around the router or weighs in excess of 10 pounds (4.5 kg). Excessive
weight on top of the router could cause damage.
10 Cisco 1003 and Cisco 1004 User Guide
If you place the router on a desk or table, do not place anything on top of it that