Advertisement
1. Solder the Cube's 9 volt positive battery wire to the solder pad
labeled "RED" on the Cube and the negative 9 volt battery wire
to the pad labeled "BLK" on the Cube.
2. Your camera should have three wires; Red (power +), Black
(ground), Yellow (video). If you have a non-Ramsey camera,
check the paperwork with the camera to be sure which wire
colors indicate positive, negative and video. The Red wire (+)
on your Ramsey camera connects to the 12 volt battery pack
positive. BE SURE YOU'RE CONNECTING TO THE
BATTERY POSITIVE BEFORE SOLDERING!
3. The camera 12 volt battery pack ground must be connected to
the camera and the Cube. The black camera wire is connected
directly to the battery negative or ground (-). Again, double
check the polarity.
4. The black camera wire, now connected to the battery negative
or ground connection (-), must also be connected to the pad
labeled "BLK" on the Cube.
5. The Yellow camera wire (video) connects to the pad labeled
YEL".
When you're finished, check your work to be sure that everything is
connected correctly and the solder pads are not shorted together by a
"blob" of solder. Read the rest of the setup instructions before applying
power.
camera power "+" input
CCD Camera
video out
camera power "-" input
-
+
red
-
+
12V Battery
Pack
yellow
black
9V Battery
Pack
•
C2000
5
black
black
red
+ -
The Cube
Advertisement
