Advertisement
INTRODUCTION
Your Cube 2000 uses the latest in monolithic circuitry to produce
a very tiny, yet full featured TV transmitter capable of excellent image
quality. Frequency stability is excellent due to the use of advanced
dielectric resonator technology. Wide bandwidth modulation allows
transmission of high resolution color or black and white video. Wireless
transmission range of up to 150 feet is possible to any standard cable
ready TV set. Using a top quality UHF TV receiving antenna can
increase range up to 1/2 mile! The Cube is so small that it can be
used in applications only James Bond could imagine. A Ramsey CCD
camera, battery and The Cube will easily fit into a cigarette pack,
baseball cap or other small enclosure.
12V Battery
CCD Camera
HOOK-UP
Hook up of The Cube is very easy
requiring the connection of just a few wires to the Cube's solder pad
areas. You must use a small pencil type soldering iron such as our
Weller WLC-100 or Radio Shack pencil iron. The component side of
the circuit board has been encapsulated to protect the precision
adjustments and specialized open chip circuits inside. You will need to
solder your camera video and ground wires and your Cube power
supply wires to the Cube 2000. Ramsey cameras need to run on their
own 12 volt DC supply. The following PC board diagram shows where
the connections will be soldered.
BE SURE TO OBSERVE PROPER BATTERY POLARITY AND
CAMERA WIRE LEAD COLORS! FAILURE TO DO SO CAN
DAMAGE YOUR CUBE AND CCD CAMERA - AN EXPENSIVE
MISTAKE! Double check all your work before applying power.
Pack
The Cube
9V Battery
Pack
•
C2000
4
Cable ready TV tuned to
cable channel 59
Advertisement
