Manitou Circus Expert Service Manual page 22

CASTING INSTALL
Install the rebound knob using a 2mm
7
hex wrench. Add a small drop of blue
Loctite to the screw before installation
to prevent the screw from backing out
during riding.
Install compression rod bolt. It helps
8
to have at least 30-50PSI in the air
chamber when tightening down the bolt
to the proper torque. Use a 12mm socket
and torque wrench and tighten to 45 –55
in lb [5.1–6.2 N m].
22
CIRCUS EXPERT SERVICE MANUAL