Adjust Cutting Depth; Connect Dust Extractor - Baier BDN 452 Instruction Manual

BDN 452, BDN 453, BDN 454, BDN 455,
BDN 463 / 4, BDN 464 / 4 and BDN 466 / 6
NOTE
The hole in the washer is off-centre.
•
3 to 7 Push on the washer (2). Match the
thread of the drive shaft (3) with the hole in the
washer (2).
NOTE
The hexagonal head screw has a left-hand thread.
•
3 to 7 Use the hexagon head screw (4) to
screw the washer (2) onto the drive shaft (3)
(left-hand thread).
•
7 Use an open-ended spanner size SW13 (8) to
tighten (10 Nm) the screw, at the same time use
the hook wrench (2) to hold the washer (7).
•
Check the fit of the diamond dry-cutting discs.
The diamond dry-cutting discs must be fitted
as described above and must be able to rotate
freely.
NOTE
If the diamond dry-cutting discs do not fit tightly, a
further 2 mm spacer disc must be fitted under the
washer.
WARNING
Risk of injuries due to cracking and breaking of
the diamond dry-cutting disc (bits of disc flying
around), caused by damaged, untrue running or
vibrating diamond dry-cutting discs.
Î During the trial run of the machine, hold the
diamond dry-cutting discs away from your body
and do not touch or grip them.
Damaged, untrue running or vibrating diamond
dry-cutting discs must be replaced immediately.
•
Carry out a trial run of at least 30 seconds
without load.
5.2

Adjust cutting depth

BDN 452, BDN 453, BDN 454, BDN 455 and
BDN 464 / 4
•
8 / 9 Use an open-ended spanner size SQ13
to undo the hexagon nut (1) on the protective
hood (2).
•
8 / 9 Turn the protective hood (2) to adjust the
cutting depth (3).
•
8 / 9 Tighten the hexagon nut (1).
BDN 463 / 4 and BDN 466 / 6
•
10 / 11 Release the clamping lever (1) at the
protective hood (2).
•
10 / 11 Turn the protective hood (2) to adjust
the cutting depth (3).
•
10 / 11 Tighten the clamping lever (1).
5.3

Connect dust extractor

BDN 452, BDN 453, BDN 454, BDN 455,
BDN 463 / 4, BDN 464 / 4 and BDN 466 / 6
•
Check the dust extractor to ensure that it is
working properly.
•
12 Push the dust extractor hose (3) firmly onto
the nozzle (2) of the protective hood (1).
NOTE
The nozzle (2) is designed to fit the suction hose
(3) of a BAIER special dust extractor.
12 When the suction hose (3) is cold, a good deal
of effort is required to push it onto the nozzle (2) of
the diamond cutter.
| 19 |