Ec Declaration Of Conformity; Machine Characteristics; Machine Parts And Controls - Baier BDN 452 Instruction Manual

EN
The vibration emission values given in this instruc-
tion manual have been measured according to a
method of measurement standardised in EN 60745
and can be used for comparison between power
tools. They are also suitable for a preliminary esti-
mate of the vibratory stresses.
The vibration emission values given represent the
main applications of the power tool. If the power
tool is used for other applications, with different
insert tools or are insufficiently serviced, this can
significantly increase the vibratory stresses over
the whole work period. For a precise estimate of the
vibration emission values, the times during which
the tool is switched off or is running but not actually
in use should also be taken into account. This can
reduce the vibration stresses over the whole work
period significantly.
WARNING
Health risk due to vibrations.
Î Additional safety measures should be taken
to protect the user, e.g. wearing anti-vibration
protective gloves, correct maintenance
of power tools and insert tools, keeping
hands warm and good organisation of work
sequences.
3.2

EC Declaration of Conformity

We herewith declare, with sole responsibil-
ity, that this product conforms to the follow-
ing standards or normative documents:
in accordance with the provisions of the Directives
2006/42/EC; 2014/30/EU; 2011/65/EU
The head of development is authorised to write the
technical documents.
These are available from:
Maschinenfabrik OTTO BAIER GmbH,
Heckenwiesen 26,
D-71679 Asperg
Thomas Schwab
Managing Director
Asperg, 01.09.2014
| 16 |
EN 60745
Armin Stiegele
Head of Development
3.3

Machine characteristics

The machines are equipped with specially
developed electronics. It monitors the speed and
the green / red indicator lights (items 13 and 14,
see Figure 1 ) help to achieve the most favourable
work progress and therefore tool-protecting working
conditions.
Visual display
Green: Speed for optimum cutting performance
Red: Speed too low – stopping
If this warning signal is ignored, i.e. the feed is not
reduced, the electronics switch off on overload.
After the diamond dry-cutting discs have stopped,
remove them from the chase. The machine can be
restarted immediately.
3.4

Machine parts and controls

(See Figure 1 )
1 ON / OFF switch
2 Handle
3 Rear roller
4 Nozzle for dust extractor hose connection
5 Rotation direction arrow
6 Washer
7 Hexagonal screw (left-hand thread)
8 Diamond dry-cutting disc
9 Protective hood
10 Front roller
11 Front handle
12 Clamping lever
(BDN 463 / 4 and BDN 466 / 6)
or hexagon head screw
(BDN 452, BDN 453, BDN 454, BDN 455 and
BDN 464 / 4)
13 Green LED
14 Red LED
 Working direction