2.7.6 Service / Maintenance / Repair; Explanation Of The Pictograms On The Diamond Channel Cutter - Baier BDN 452 Instruction Manual

EN
•
Allow the insert tools, tool holders and other
parts cool in the immediate vicinity of the
work area after use.
The equipment can be very hot after use. Do not
touch or grip the parts. Risk of injury.
•
Additional signs or other, non BAIER-
specific parts may not be screwed or
riveted onto the motor, handle, gearbox or
protective housing.
This could damage the power tool and cause
malfunctions to occur.
•
Avoid unnecessary noise emissions.
•
Note and follow the safety and work
instructions for the accessories used.

2.7.6 Service / Maintenance / Repair

•
If the power tool is dropped or becomes wet,
have it checked.
A possibly damaged power tool is dangerous
and no longer safe to operate. Before using
the power tool again, have it checked by our
customer service or an authorised service
centre of Maschinenfabrik OTTO BAIER GmbH.
•
Repair and maintenance work may only be
carried out by an authorised workshop of
Maschinenfabrik OTTO BAIER GmbH.
Otherwise, all liability and warranty claims
against Maschinenfabrik OTTO BAIER GmbH
expire.
•
Ensure that original BAIER spare parts and
original BAIER accessories only are used
when needed.
Original parts are available from authorised
dealers. Use of non original parts can cause
damage to the machine and an increased risk of
accidents.
•
Regular servicing by Maschinenfabrik OTTO
BAIER GmbH or a servicing and repair
company authorised by us is specified.
Many accidents are caused by poorly serviced
and maintained power tools.
| 14 |
2.7.7 Explanation of the pictograms
on the diamond channel cutter
The CE mark on a product means that the
product conforms with all the applicable
European regulations and has been
subjected to the prescribed conformity
assessment procedures.
Protection class II equipment
The machine is insulated in such a way
that it has no exposed metal parts that
could be live in the event of a fault. It does
not have a protective earth conductor.
Environmentally friendly disposal of
waste equipment
Waste equipment contains valuable
recyclable materials which should be
reused or recycled. Batteries, lubricants
and similar materials must not be allowed
to get into the environment.
Therefore, please dispose of waste
equipment through suitable collection
systems.
Wear hearing protection!
The typical A-weighted sound pressure
level of this power tool is over 85 dB (A)
– wear ear protectors when working with
the tool!
Wear protective equipment!
Read the instruction manual!
Before starting any work with or on the
machine, this instruction manual, the
safety instructions and the warnings must
be read through carefully and observed.