Samsung HG43NF690U Installation Manual page 37

Setting Auto Initialize
When you clone settings from one TV to another, you clone both the guest side menu and hotel side menu settings:
Picture, Sound, Input, Channel, Setup, and Hotel Setup. This lets you set nearly all of the menu values on your hospitality
TVs to the same, standard settings. If you allow guests access to the guest side menus, for example the Picture menu,
they can change the settings in those menus so they are no longer standard. If you set the Setting Auto Initialize function
to on the TV automatically restores (initializes) any guest-side menu values to the cloned, standard values when the TV
is turned off and then turned on again. Note that Setting Auto Initialize works on cloned guest side menu values only.
Settings which have not been cloned are ignored.
The table below lists the settings that are restored to their cloned values when you set the Setting Auto Initialize function
to On.
✎ The menu item does not support depending on the models.
Picture
Picture Mode
Picture Size Settings
Expert Settings
Menu Item
Picture Size
Auto Wide
4:3 Screen Size
Fit to Screen
Backlight
Cell Light
Brightness
Contrast
Sharpness
Color
Tint (G/R)
Apply Picture Settings
Digital Clean View
Auto Motion Plus Settings
LED Clear Motion
Local Dimming
Contrast Enhancer
HDR+ Mode
Film Mode
Color Tone
White Balance
Gamma
. HLG
. ST.2084
. BT.1886
RGB Only Mode
Color Space Settings
Auto Motion Plus
Blur Reduction
Judder Reduction
LED Clear Motion
2 Point
10 Point Settings
20 Point Settings
Color Space
Color Gamut
Color
Red
Green
Blue
R-Gain
G-Gain
B-Gain
R-Offset
G-Offset
B-Offset
10 Point
Interval
Red
Green
Blue
20 Point
Interval
Red
Green
Blue
37
English