Table of Contents
Advertisement
Section 3 - Configuration
This mode is used when your ISP provides you with a set IPv6 addresses that does not change. The IPv6 information is manually entered in your
IPv6 configuration settings. You must enter the IPv6 address, subnet prefix length, default gateway, primary DNS server, and secondary DNS server.
Your ISP should provide you with this information.
Use.Link-Local.
The link-local address is used by nodes and routers when
Address:
communicating with neighboring nodes on the same link.
This mode enables IPv6-capable devices to communicate
with each other on the LAN side.
IPv6.Address:
Enter the WAN IPv6 address for the router here.
Subnet.Prefix.Length:
Enter the WAN subnet prefix length value used here.
Default.Gateway:
Enter the WAN default gateway IPv6 address used here.
Primary.IPv6.
Enter the WAN primary DNS server address used here.
DNS.Address:
Secondary.IPv6.
Enter the WAN secondary DNS server address used here.
DNS.Address:
LAN.IPv6.Address:
These are the settings of the LAN (Local Area Network)
IPv6 interface for the router. The router's LAN IPv6 Address
configuration is based on the IPv6 address and subnet assigned
by your ISP. (A subnet with prefix /64 is supported in LAN.)
D-Link DIR-808L User Manual
Static IPv6 Address Connection
66
Advertisement
Table of Contents
