Important Safety Information - Greenlee 910FS Instruction Manual

Important Safety Information

General
Use this unit for the manufacturer's intended purpose only, as described in this manual.
Any other use can impair the protection provided by the unit. Do not use the splicer on
live fibers.
Environmental Conditions
This tool is designed to operate at a maximum relative humidity of 95% and at altitudes
up to 5000 m (16,400 ft).
Before Applying Power
Verify that the tool is set to match the available line voltage and the correct fuse is
installed.
Do Not Operate in Explosive Atmosphere
Do not operate the tool in the presence of flammable gases or fumes.
Do Not Remove Instrument Cover
Do not remove the cover of the unit for any reason. It contains no user-serviceable parts.
Greenlee / A Textron Company
This symbol is used to call your attention to hazards or unsafe practices which could
result in an injury or property damage. The signal word, defined below, indicates the
severity of the hazard. The message after the signal word provides information for
preventing or avoiding the hazard.
Immediate hazards which, if not avoided, WILL result in severe injury or death.
Hazards which, if not avoided, COULD result in severe injury or death.
Hazards or unsafe practices which, if not avoided, MAY result in injury or property
damage.
Read and understand all of the instructions and safety information in
this manual before operating or servicing this tool.
Failure to observe this warning could result in severe injury or death.
SAFETY
ALERT
SYMBOL
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
910FS Splicer