Splice Mode Menu (S-Mode) - Greenlee 910FS Instruction Manual

Splice Mode Menu (S–Mode)
(1) Select Splice Mode
Select "S–Mode" to access the available splicing modes. Use p and q to highlight the
desired splicing mode. Then press
Select an appropriate splice mode for the type of fiber to be spliced, and press p or q
to select the splice mode. Then press
Note: "1 AUTO SM/NZ/DS/MM" mode is recommended for splicing in most cases. In
this mode, the splicer automatically adjusts splice parameters according to the fiber
type.
(2) Edit Splice Mode
Splicing parameters in each splice mode can be modified.
In "Select Splice Mode" menu, press u to enter "Edit Splice Mode" and modify the
splice mode as shown below.
Press p or q to select the parameter to be modified, and then press
parameter setting.
Press p or q to modify the parameter, and then press
Greenlee / A Textron Company
8
to confirm.
8 to confirm.
22
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
910FS Splicer
8
to enter the
8
to confirm.